Operating instructions
Auto Setup
Quick Start Guide
12
Auto Setup
Search and store TV channels automatically.
•
T hese steps are not necessary if the setup has been completed by your local dealer.
•
Please complete connections (p.10, 11) and settings (if necessary) of the connected equipment before starting Auto Setup.
For details of settings for the connected equipment, read the manual of the equipment.
TV
1
Plug the TV into mains socket and switch On
•
T akes a few seconds to be displayed
•
If the red LED shows on the TV, press the Standby On / Off switch on
the remote control for about 1 second.
2
Select the language
Menüsprache
Deutsch D anskPolskiSrpski
E nglish Svenska č eština Hrvatski
Français N orsk Magyar Slovenščina
Italiano Suomi Slovenčina Latviešu
E spañol Türkçe Български eesti keel
P ortuguês Еλληνικά RomânăLietuvių
N ederlands
select
set
3
Select your country
Country
G ermany D enmark Poland
Austria Sweden Czech
France N orway Hungary
I taly Finland Slovakia
Spain Luxembourg Slovenia
P ortugal Belgium
E stonia Switzerland Netherlands
L ithuania M alta Turkey
O thers A ndorra Greece
Croatia
select
set
•
D epending on the country you select,
select your Region or store the Child Lock-
PIN number (“0000” cannot be stored) by
following the on screen instructions.
4
Select the mode you want to tune
D
A
TV Signal Selection
DVB-C
DVB-T
Analogue
Start Auto Setup
tune / skip tuning
select
: tune (search for the available channels)
: skip tuning
5
Select [Start Auto Setup]
D
A
TV Signal Selection
DVB-C
DVB-T
Analogue
Start Auto Setup
access
select
•
Auto Setup will start to search for TV channels and store them.
T he stored channels and sorted channel order vary depending on the country, area,
broadcasting system and conditions of signal reception.
Auto Setup screen varies depending on the country you select.
1 [DVB-C Network Settings]
•
D epending on the country you select, select your cable provider beforehand by
following the on screen instructions.
DVB-C Network Settings
Frequency
Auto
N etwork ID
Start Auto Se
tup
Auto
access
select
[Start Auto Setup]
jkl
ghi
mno
tuvpqrs
wxyz
abc def
N ormally set [Frequency] and [Network ID] to [Auto].
If [Auto] is not displayed or if necessary, enter [Frequency] and [Network ID] specified by
your cable provider with numeric buttons.