Operating Instructions

Viewing 3D images
33
Attaching Ferrite Core
B e sure to attach the provided ferrite core to the charging cable to reduce interference or electrical noise.
1 Attach the ferrite core as close to USB connector of
the charging cable as shown.
M ini USB connector
U SB connector
2 Close the ferrite core until it clicks.
U SB connector
Charging the 3D Eyewear
Preparations
•
Set [USB Charge in Standby] in the Setup menu to [On].
•
Switch off the 3D Eyewear.
1 Turn the TV to Standby mode with the remote control.
2 Connect as shown in the diagram.
•
T he indicator lamp lights red, and charging starts.
•
When the indicator lamp turns off, charging is completed. (Approximately 2 hours required)
3 After charging is completed, remove the charging cable.
M ini USB connector
U SB connector
Note
•
D o not turn the TV Off with Mains power On / Off switch during charging.
•
F or the specification of the rechargeable battery in the 3D Eyewear (p. 127)
Storing and cleaning the 3D Eyewear
•
U se the supplied 3D Eyewear case to store the 3D Eyewear.
•
Avoid storing the 3D Eyewear in hot or highly humid locations.
•
U se a clean, soft and dry cloth to wipe the 3D Eyewear. Otherwise, dirt or dust may scratch the eyewear.
•
D o not use benzene, thinner, or wax on the 3D Eyewear, as doing so may cause the paint to peel off.
•
D o not submerge the 3D Eyewear in liquid such as water when cleaning.
•
During the long period of disuse, full charge the 3D Eyewear once every 6 months to keep the battery performance.
•
A s the liquid crystal shutters (lens) are fragile and easily broken, be very careful when cleaning them.