User Guide

English

Installation procedure

Insert the two projections on the

stand into the two holes in the base

of the display as shown in the

illustration at left.

Insert and tighten the four M5-30

screws, with two screws each at the

left and right.

2. Prepare the Wide Plasma Display.

Display unit

Cloth or similar

Remove the screws and covers and keep

them for possible future use.

*The screws may be used again if the

installation method is changed to the

waIl-stand method, so keep them in a

safe place so that they do not get lost.

• Spread a clean cloth or similar material over a level floor or base, and place the display unit on it face down.

• Lock the casters before installing the display.

Note

3. Install the display to the stand.

Unlock

Lock

ST42PF3E改-4-11/10最終 00.11.22 8:48 AM ページ 5