Operating instructions

32
English
QR34653
Inserting and Removing Disc
Inserting Disc
1 Press down the DISC EJECT button once and
release it.
A few moments after the ACCESS/PC indicator
blinks, the cover of disc insertion block will open
slightly.
2 Gently open the cover by hand until it stops.
3 Insert the disc, in Round DVD Holder, into the
disc guide until it stops.
Note that the recording/playback surface of disc
must face the inside of DVD video camera/
recorder. The orientation for inserting the disc
into the disc guide is also predetermined: Load
the disc correctly, referring to the figure below.
•
The disc exposed portion must face in the same direction
as the lens, as shown in figure.
• The recording/playback side must face the inside (DVD
video camera/recorder).
If the disc is not correctly inserted, the cover will not
close. Never try to forcibly close the cover: This
could cause damage. Reinsert the disc properly.
4 Push the section marked “PUSH CLOSE” on
the cover of disc insertion block, to close the
cover.
5 Turn the DVD video camera/recorder on
(O VIDEO or N PHOTO).
When “DISC ACCESS” disappears, the DVD
video camera/recorder is ready for recording.
lIdentifying recording/playback
sides of disc:
Single sided disc:
The recording/playback side is
opposite to the printed label.
Double-sided disc:
The recording/playback side
of “SIDE A” is opposite to the
“SIDE A” marked side.
The recording/playback side
of “SIDE B” is the “SIDE A”
marked side.
Disc cover
DISC EJECT
button
PUSH CLOSE portion
Disc
guide
Correct
orientation
Incorrect
orientation
Incorrect orientation
“SIDE A” mark
The opposite side is
the “SIDE A”
recording/playback
side.
ENG.book 32 ページ ２００３年３月２０日 木曜日 午後４時４９分