Operating Instructions

4.3.2 Assembling lobby station modules
The lobby station is composed of a combination of
modules according to the number of rooms connected
to.
–
See page 6 for information on the composition of
each module.
– See page 10 for information on the items included
with each module.
Example: lobby station for camera module ´ 1 pcs. +
button module ´ 3 pcs. + blank panel ´ 1 pcs.
1 Attach each module (B) to the frame (A) as shown
below.
R Starting from the camera module, attach each
module in order from the top. (B-1—B-5)
R Insert the holders (
1
) into the slots (
2
) on the
both sides of the frame.
R The combination of modules changes according
to the number of rooms connected to.
B
- 1
B
- 2
B
- 3
B
- 4
B
- 5
A
B
2
1
2 Hold down the left and right side plates
(C), secure
them using the screws (D). Make sure that each
module is securely attached.
R The included number of screws differs according
to the back box type (large or small) connected
to.
CC
D
D
4.3.3 Connecting flat cables
1 Remove each terminal cover
(A) from each module
(A-1).
R Remove the terminal cover of the attached
module.
2 Connect the flat cable (B) from the camera module
to the module of the next button.
R Starting from the camera module, attach each
module in order from the top.
3 Connect the flat cables (B) to all of the remaining
modules.
4 After connections are completed, reattach each
terminal cover (A) to each terminal (A-2). Make sure
each module is securely attached.
R C: 1 of the included flat cables will not be used
Example: lobby station for camera module ´ 1 pcs. +
button module ´ 3 pcs. + blank panel ´ 1 pcs.
B
B
B
C
A
A
A
- 1
A
- 2
B
26
4. Installation