Operating Instructions

4.3.4 Connecting 2 frames of a lobby station
using the extension cable
When connecting 2 frames of a lobby station together,
connect
them using the VL-VM801 extension cable (sold
separately; A) as shown below.
Example: lobby station for camera module ´ 1 pcs. +
button module ´ 8 pcs. + blank panel ´ 2 pcs.
(2 of the included flat cables will not be used)
A
4.3.5 Connecting the VIGIK panel (for
France)
The lobby station is compatible with VIGIK installation.
Refer to the documentation of the VIGIK for information
about installation.
Required items
–
VIGIK system (user supplied)
– Cable that connects the lobby station to the VIGIK
system (user supplied)
Supported sizes
When selecting a VIGIK system, select one that meets
the following guidelines.
Max. 9 mm
Max.
44 mm
Max.
36 mm
Max. 32 mm
Max.
25 mm
Max. 18 mm
1. Remove the waterproof rubber from the panel, and
then
remove the screws (A) on the left and right side
of the module and panel.
A
2. As
shown in the following illustration, securely attach
the VIGIK by following the instructions in the
documentation for the VIGIK.
R The word "UP" should be facing up.
A Waterproof rubber (included with the VIGIK
panel)
B VIGIK reader (user supplied)
C Attachment nut or similar part (supplied with
the VIGIK)
B
C
A
3. Attach the VIGIK panel to the frame.
a. As shown in the following illustration, attach the
VIGIK panel to the frame (A).
b. Securely attach the cable (user supplied; B, C)
by
following the instructions in the documentation
for the VIGIK.
c. Align the protrusions of the cover with the holes
of the plate (D).
d. Make sure to reattach the panel and module by
securing the screws (E).
A
E
B
C
D
D
D
27
4. Installation