Installation Guide

● Cable clamp

Fix the connection cable using the provided cable clamp as

follows.

1 Attach the cable clamp fixing belt to the fixing hole

on the rear, and pass the cable through the holder

part of the cable clamp.

Pull the cable clamp fixing belt to confirm that the fixing

belt is attached firmly.

2 Close the clamp.

3 Slide the cable clamp toward the connector end of

the connection cable, and then hold the connector

end of the connection cable.

Make sure that the connection cable is connected firmly.

Note:

 • Overheadview

(1) Hold the connector end of the connection cable by

tightening the clamp. It may be difficult to hold the

connector end when the cable clamp is not slid all the

way to the connector end side.

(2) To slide the cable clamp in the direction of arrow indi-

cation (2), slide it while keeping the knob pulled down.

Holder part

Cable clamp

fixing belt

(1)

(2)

(1)

Knob

Connector end of the

connection cable

Clamp