Installation Guide

56
Set up terminal alarm [Advanced terminal alarm setup]
Configure the settings relating to the recording triggered by an alarm signal supplied to the ALARM/CONTROL connector of the
recorder from an external alarm device such as a door sensor.
Configure the necessary settings for each alarm input terminal of the ALARM/CONTROL connector on the rear panel of the
recorder.
■ Advanced terminal alarm setup
[Mode]
Select the action to be taken when an alarm signal is sup-
plied.
Recording & alarm action: All event actions will be per-
formed according to the settings.
Recording only: Only recording, filing of event logs, and
moving the camera to a preset position will be per-
formed.
Off: Only filing of event logs will be performed.
Default: Recording & alarm action
[Setup by terminal]
Set up individual terminals numbered from 1 to 9.
[Recording camera]
Select the camera for recording. When "Off" is selected,
recording will not be performed.
All: Applies all the registered cameras for recording.
Default: Camera number associated with the terminal num-
ber
Note:
 • Whenmanycamerasareregisteredand"All"isselected
for "Recording camera", the start of alarm recording may
be delayed depending on the cameras. It is recommend-
ed to perform pre-event recording.
[Preset]
Select the camera preset position (001 to 256) to which the
camera is to be moved when an alarm signal is received. If
"---" is selected, the camera will not be moved to a preset
position.
[Terminal output]
Choose whether or not to output an alarm signal from the
alarm output terminal of the ALARM/CONTROL connector
on the recorder's rear panel when an alarm signal is
received.
On: Outputs alarm signals.
Off: Does not output alarm signals.
Default: On
[Terminal input]
Select the terminal status for supplying an alarm signal to the
alarm terminal.
N.O. (Normally Open): Signals will be supplied when
short-circuited.
N.C. (Normally Close): Signals will be supplied when
open-circuited.
Default: N.O.
[Back] button
Click the button after completing the settings. The screen
returns to the [Event setup] tab.
Note:
 • RefertotheOperatingInstructions(PDF)forfurtherinfor-
mation about camera preset positions.