Installation Guide

ManualsBrandsPanasonic ManualsComputer HardwareWJ-NV200

New functions (Software V2.10)

Due to software upgrade, the following new functions have become available.

Details on the new functions

Reference pages

The "Dual mode" that can record the same images and audio on two

HDDs is added to the HDD operational mode.

Refer to "■ About the HDD operational mode" (page 3) for further

information.

 This function supports only the models in which 2 HDDs can be

installed.

When using this function, disk size of two hard disk drives to be

used shall be the same.

 After replacing one of the HDDs, it is impossible to copy data on

the existing HDD to the replaced HDD using this software. (No

recovery function is featured.)

 When the existing HDD (not replaced one) doesn’t exist, the

recorded data of a certain period* after replacing the HDD cannot

be played.

* In case of overwriting in one month, up to two days.

Installation Guide

page 81

The alarm history relating to the i-VMD of the camera is added.

Intruder detection: Camera alarm (Intruder detection)

Loitering detection: Camera alarm (Loitering detection)

Direction detection: Camera alarm (Direction detection)

Scene change detection: Camera alarm (Scene change detection)

 This function is available when “On” is selected for “Additional

alarm area data” on the camera. For further information about

this setting, refer to the operating instructions of the camera in

use.

Operating Instructions

page 38, page 62

Important:

Note:

Summary of content (6 pages)

PAGE 1
New functions (Software V2.10) Due to software upgrade, the following new functions have become available. Details on the new functions Reference pages The "Dual mode" that can record the same images and audio on two HDDs is added to the HDD operational mode. Installation Guide page 81 Refer to "■ About the HDD operational mode" (page 3) for further information. Important:  This function supports only the models in which 2 HDDs can be installed.
PAGE 2
Details on the new functions Reference pages The following camera setting items can be configured on the recorder.  Transmission priority (Frame rate/Advanced VBR) Installation Guide page 48 Note:  For further information about these functions, refer to the operating instructions of the camera in use. The release key number of the camera's extension software can be registered in the camera from this product now.
PAGE 3
Details on the new functions Reference pages A new parameter is added to the setting of "Duration" of "Live sequence" Installation Guide under "Live monitor". (The underlined parameter is newly added.
PAGE 4
■About the HDD operational mode In this document, the conventional operational mode that records images from the cameras on a single HDD is referred as "Single mode" and the newly added operational mode that records images on two HDDs is referred as "Dual mode". The operational mode can be changed on the "HDD management" page (Page 80 in the Installation Guide) Change the HDD operational mode [Change the operation mode of HDD] Step1 Click the [Execute >] button next to "Change the operation mode of HDD".
PAGE 5
New functions (Software V2.00) Due to software upgrade, the following new functions have become available. Details on the new functions Menu to configure the settings The following two NTP server addresses can be registered.  Primary server address (The former name: NTP server address)  Secondary server address [Advanced setup] > [Network] > [NTP/SNMP] The following camera setting items can be configured on the recorder.
PAGE 6
New functions (Software V1.50) Due to software upgrade, the following new functions have become available. Details on the new functions Menu/Panel to configure the settings The following camera setting items can be configured on the recorder.