Installation Guide

19
Uninstalling the Camera
Caution:
• Make sure you perform the steps below carefully
and exactly when uninstalling the camera and
decorative cover. Failure to do so creates the risk
of damage to the camera.
 Removing the Decorative Cover
Note that you need to separate the two parts of the
decorative cover in order to remove it.
1. Unhook the two parts of the decorative cover.
Press upwards on the decorative cover at the points
marked
(indicated by the arrows, in the
illustration below) to unhook the two parts from
each other.
* When removing the decorative cover, the direction
to press (

) is shown on the side of the decorative
cover.
Unhook
Back
Fix securely
Press
Fix securely
Press
 Uninstalling the Camera
The camera and its base unit are secured by screws.
This configuration provides double anchoring, and you
should use the following procedure to uninstall the
camera.
1. Remove the fixing screw that secures the camera to
the camera mounting base.
Put the screw in a place where it will not become
lost.
2. Remove the camera from the camera mounting
base.
Rotate the camera in the direction indicated by the
arrow and remove it.
Camera
Camera
Mounting
Base
Fixing screw
Rotate
15
°
After loosening
the screw, press
upwards on the
camera and then
remove it.
3. Remove the safety wire from the camera mounting
base.