Operating Instructions

22
To enter a blank space in the camera ID
Move the cursor to "SPACE" and press the
[SET] button.
To erase all characters in the editing area
Move the cursor to "RESET" and press the
[SET] button. All characters in the editing
area disappear.
To determine the display position of the
camera ID
1. Move the cursor to "POSI", and press
the [SET] button. The display in the
figure appears and the camera ID is
highlighted.
2. Move the camera ID to the desired
position.
3. Press the [SET] button to fix the position
of the camera ID.
2
Light Control Setting
1. Move the cursor to "ALC/MANUAL" and
select "ALC" or "MANUAL". When you
select "ALC", backlight compensation
"ON" or "OFF" can be set.
Default setting: ALC
2. When "MANUAL" is selected, press the
[SET] button and the "MANUAL CONT"
menu appears. Press the [LEFT] or
[RIGHT] button for iris adjustment.
WV-CZ392
**MANUAL CONT**
IRIS ···I···+64
CLOSE OPEN
RET TOP
(1) ALC Mode with BLC "ON"
CZ392
1. Press the [SET] button after selecting
"ALC". The "ALC CONT" menu appears.
2. Move the cursor to the BLC parameter
and select "ON".
3. If you want to adjust the video output
level, adjust the "I" cursor for "LEVEL".
(2) ALC Mode with BLC "OFF"
CZ392
1. Move the cursor to "BLC" and select
"OFF". (When you select "MANUAL", BLC
is not available.)
2. Move the cursor to "MASK SET
" and
press the [SET] button, the mask setting
menu appears.
3. To mask an area where backlight is
bright, move the cursor to the area and
press the [SET] button. The mask turns
white.
Once the flicker display moves to the
mask area, white and stripe will display
alternatively in this area.
Repeat this procedure to mask the
desired areas.
BACK LIGHT COMP
**ACL CONT**
BLC ON
RET TOP
LEVEL
·I····· 0
BACK LIGHT COMP
**ACL CONT**
BLC OFF
RET TOP
LEVEL
·I····· 0
MASK SET
Blinking