Operating Instructions

24
Note:
•
When the selected shutter speed caused
flicker on condition that fluorescent lamps
stay on, change this setting to "OFF".
•
When "MANUAL" is selected for "ALC/
MANUAL" and "FIX" is selected for "SENS UP",
"AUTO" can be selected for "SHUTTER", but
the AUTO function is not available.
4
Gain Control Setting
Select "ON (LOW)", "ON (MID)", "ON (HIGH)" or "OFF".
Default setting: ON (MID)
Note:
•
Even if "AGC" is set to "ON" and if the noise
reduction functionis enabled, after images may
be produced by shooting a moving object.
•
For more information, refer to Digital
Noise Reduction on page 25.
5
SENS UP Setting
The electronic sensitivity enhancement
mode changes as follows:
CZ392
When "OFF" is selected for "SUPER-D6",
the electronic sensitivity enhancement
mode changes as follows:
CZ492
When "ON" is selected for "SUPER-D6",
the electronic sensitivity enhancement
mode changes as follows:
CZ492
Default setting: OFF
Note:
•
The difference between "AUTO" and "FIX"
are as follows:
AUTO:
If selected "X32 AUTO", SENS UP
will increase up to X32 automatically.
FIX:
If selected "X32 FIX", SENS UP will
increase up to X32 fixedly.
•
Noise or spots may appear in the picture
when the sensitivity of the camera is
increased.
6
White Balance Setting
1.
ATW1/ATW2:
in this mode, the camera
continually monitors the
color temperature of the light
source and automatically
adjusts white balance.
ATW1:
2700 K to 6000 K.
ATW2:
2000 K to 6000 K (Mode
recommended for sodium lighting)
Default setting: ATW1
Proper white balance may not be possible
under the following conditions. In such
cases, use the "AWC" while balance mode.
•
When the subject contains mostly dark
colors
•
When the light source is a deep blue sky
or twilight
•
When illumination of the subject is low
(1)
The white balance of the camera is
automatically adjusted at ATW1 and ATW2.
(2) For fine adjustment of ATW1/ATW2, press the
[SET] button. The ATW1/ATW2 fine adjustment
menu appears on the monitor screen.
2.
AWC:
Automatic White Balance Control
In this mode, the supported color
temperature range is approximately 2000 K
to 10000 K. This mode is best in locations
where the light source is constant.
(1) Select "AWC" and press the [SET] button.
(2) "
PUSH SET" is highlighted on the display
while white balance adjustment is being
performed.
•
"PUSH SET" becomes unhighlighted again
when white balance adjustment is complete.
256 512
128
AUTO
AUTO
AUTO FIX FIX
FIX
FIX FIX FIX FIX
FIX FIX FIX
AUTO AUTO AUTO
OFF
OFF
256 512
128
AUTO
AUTO
AUTO FIX FIX
FIX
FIX FIX FIX FIX
FIX FIX FIX
AUTO AUTO AUTO
OFF
OFF
AUTO
OFF
RET TOP
**AWT1**
R ···I··· 0
B ···I··· 0