Operating Instructions

33
Move the "+" cursor to the place on the
blemish position. After moving the "+"
cursor to a position where the blemish
looks inconspicuous, press the [SET]
button. Consequently, the blemish
compensation position is set up and
the "PIX OFF" menu is restored. After a
blemish compensation position is set up,
"*" is attached at the right of the number.
3. If you would like to delete a blemish
compensation position, move the cursor to the
applicable number and press the [SET] button.
The blemish compensation position
setting screen appears. The blemish
compensation position is deleted and
"*" is also deleted from the right of the
number by pressing the [RIGHT] and
[LEFT] buttons for more than 2 seconds.
6
REFRESH
Move the cursor to "
→
PUSH SET" to the
right of "REFRESH" and press the [RIGHT]
and [LEFT] buttons at the same time for
more than 2 seconds. Then, the Refresh
operation is started.
The refresh function corrects the camera
position when it starts to deviate from the
preset positions.
7
CAMERA RESETTING
Move the cursor to "
→
PUSH SET" to the
right of "CAMERA RESET" and press the
[RIGHT], [LEFT], and [SET] buttons at the
same time for more than 2 seconds.
The camera is reset to the factory default settings.
8
SER.NO.
Display the serial number of this unit.
Note:
•
Any of the following cannot be reset to the
factory defaults: Preset Position Setting
(POSITION SET, ALC/MANUAL, AF MODE,
SCENE FILE), Communication Setting,
Password Lock Setting, PIX OFF setting.
•
In case of performing this operation on
the condition that the cursor is positioned
on other than CAMERA RESET, you
cannot perform the operations on the
menu thereafter. In that event, set the
camera menu to ON again.

Communication setting
Move to the cursor to "COMMUNICTION" and
select "RS485
" or "COAX" or "COAX (RCV)".
COAX:
Communication is carried out in
the coaxial multiplex system.
COAX (RCV):
If our receiver (WV-RC100,
WV-RC150, WV-RC170) is
used, select "COAX (RCV)".
RS485:
Communication is maintained
through the RS485 terminal.
Selecting "RS485
" and the [SET]
button is pressed, the "RS485
SETUP" menu is displayed.
Default setting: COAX
•
Changing the Camera
Communication Parameters for
RS485.
Move the cursor to the item and select
the parameter.
Unit Number
In an RS485 chain each unit must have a
unique number.
Sub Address
Do not set. When use Pelco
communication, press the [RIGHT] button,
the sub address will display "----P", unit
number will display "P1 D96", at this time
Pelco-P address will be "1", Pelco-D
address will be "96". Unit address can be
changed by changing unit number.
**COMMUNICATION SETUP**
COMMUNICATION COAX
RET TOP
UNIT NUMBER
SUB ADDRESS
BAUD RATE
DATA BIT
PARITY CHECK
STOP BIT
XON/XOFF
WAIT TIME
ALARM DATA
DELAY TIME
1
-----
19200
8
NONE
1
NOT USE
OFF
AUTO
2
OFF
RET TOP
**RS485 SETUP**