Operating Instructions
35
AGC SENS UP SHUTTER
INDOOR (L) MID OFF OFF
INDOOR (H) HIGH X2 AUTO OFF
OUTDOOR (L)
MID OFF AUTO
OUTDOOR (H)
HIGH X2 AUTO AUTO
BW DNR WHITE BAL
INDOOR (L) OFF LOW ATW1
INDOOR (H) OFF HIGH ATW1
OUTDOOR (L)
AUTO LOW ATW2
OUTDOOR (H)
AUTO HIGH ATW2
2. Move the cursor to "LOAD", and then
press the [SET] button.
This will cause the setup you selected for
SCENE in step 1 to be applied to the image.
Language setting
1. Move the cursor to "LANGUAGE", and
then press the [SET] button.
2. On the 8-language selection menu that
appears, select the language you want to
use. The factory default setting is English.
3. Move the cursor to "SET", and then press
the [SET] button.
The item that was set flashes when the
language is being changed and stops
flashing when the language has been
changed. Do not operate the system
controller when changing settings.
After switching the language, the title
set in the former language will be
disappeared.
If you have selected Japanese as the
language, only the IDs and titles can be
set in katakana.
The LANGUAGE display remains in
English even when the language setting
is changed.
LANGUAGE ENGLISH
SET
RET TOP
**LANGUAGE SETUP**
Quick setup
Move the cursor to "
→
QUICK SETUP", and press
the [SET] button. Quick setup menu appears.
More information, please refer to settings on
page 21.
Password lock setting
Note:
•
For security, do not operate your VTR for
recording while the password menus are
displayed on the monitor.
•
A 3-digit number is used for a password
to limit access to all settings.
1. Move the cursor to "PASSWORD LOCK".
("ON" or "OFF")
Note:
•
"ON" or "OFF" can be selected only after
going through the password verification.
OFF:
You can change all settings.
ON:
You cannot change all settings.
Default setting: OFF
2. Press the [SET] button.
Password Verication
3. The password verification menu appears.
QUICK SETUP
PASSWORD LOCK OFF
CAMERA
PRESET POSITION
SPECIAL
COMMUNICATION
SCENE SELECT
LANGUAGE
** PASSWORD? **
OK RESET
NEW PASSWORD
RET TOP
0 1 2 3 4 5 6 7 8 9