Operating Instructions

9
Precautions for installation
Avoid installing this product in the follow-
ing locations.
•
Location where it may get wet from rain or
water splash.
•
Locations where a chemical agent is
used such as a swimming pool.
•
Locations subject to steam and oil
smoke such as a kitchen, Locations near
flammable gas or vapor.
•
Locations where radiation or x-ray
emissions are produced.
•
Locations where corrosive gas is
produced, Locations where it may be
damaged by briny air such as seashores.
•
Locations where the temperature is not
within –10 °C to +50 °C.
•
Locations subject to vibrations (This
product is not designed for on-vehicle
use.)
Avoid moist or dusty places to install this
system.
Otherwise, lifetime of the internal parts may
be shortened.
Avoid installing this product in a place
with a high level of noise.
Installation near an air conditioner, an air
cleaner, a vending machine, or the like
causes noise.
Be sure to remove this product if it is not
in use.
Keep the camera cable away from the
lighting cable.
Failure to observe this may cause noise.
The following points as well as the
contents of "Warning" and "Caution"
shall be observed.
Panasonic assumes no responsibility
for injuries or property damage resulting
from failures arising out of improper
installation or operation inconsistent with
this documentation.
Installation work shall be performed in
accordance with the technology standard
of the electric installation.
This product is designed to be used
indoors.
This product is not operable outdoors.
Do not expose the product to direct sunlight
for hours and do not install the product near
a heater or an air conditioner. Otherwise, it
may cause deformation, discoloration and
malfunction. Keep the product away from
water and moisture.
Installing place
Contact your dealer for assistance if you
are unsure of an appropriate place in your
particular environment.
•
Make sure that the installation area is
strong enough to hold the product, such
as a concrete ceiling.
•
Install the camera in the foundation area
of the architecture or where sufficient
strength is assured.
•
If a ceiling board such as plaster board is
too weak to support the total weight, the
area shall be sufficiently reinforced.