Installation Guide

17
When installing the camera on a wall or a ceiling, there are two methods as specified below.
• Using a two-gang junction box
• Use the supplied mount bracket
IMPORTANT:
• Procure 4 screws (M4) to secure the camera attachment (accessory) or the mount bracket
(accessory) to a wall or a ceiling according to the material of the installation area. Do not use
wood screws and nails.
For mounting a camera on a concrete ceiling, use an anchor bolt (for M4) or an AY plug bolt
(M4) for securing.
(Recommended tightening torque M4: 1.6 N·m {1.18 lbf·ft})
• Mount the camera attachment (accessory) in consideration of the camera angle in accordance
with the instructions (
☞ pages 18 and 19).
• Required pull-out capacity of a single screw/bolt is 196 N {44.06 lbf} or more.
• If a ceiling board such as plaster board is too weak to support the total weight, the area shall
be sufficiently reinforced.
The mounting conditions of the camera are described as follows:
Installation
place
Appropriate mount
bracket
Recommended
screw
Number of
screw
Minimum pull-out
strength (per 1 pc.)
Ceiling/wall Two-gang junction box M4 4 pcs.
196 N {44.06 lbf}
Ceiling/wall* Mount bracket (accessory)
(Approx. 350 g {0.77 lbs.})
M4 4 pcs.
196 N {44.06 lbf}
* The conditions for securing the mount bracket to a wall or a ceiling are described here.
Preparations