Installation Guide
19
Using the mount bracket (accessory)
Note:
• When the camera is mounted on the wall or ceiling with a hole for cable running, or the camera
is mounted using open wiring, the mount bracket is used.
IMPORTANT:
• If open wiring is conducted, be sure to use conduits
and run the cables inside the tubes to protect the
cables from direct sunlight.
• Installation work shall be such that there is no exposure
to water into the architecture through the conduits hav-
ing been joined.
z Loosen two fixing screws on both ends of the base cover (accessory) by using the bit for tam-
perproof screw (accessory), and remove the base cover (accessory).
When using a conduit, use a hexagon wrench (ISO 2936, width across flats S=5 mm {13/64
inches}) or other tool and also remove the cap for the female thread for the conduit.
Note:
• The female thread for conduit is compliant with ANSI NPSM (parallel pipe threads) 3/4 inch or
G3/4 of ISO 228-1.
Conduit
Mount bracket (accessory)
Base cover (accessory)
Ca
p
for the female thread for the conduit
%DVHFRYHUƄ[LQJVFUHZ