WV-CP220 Series Operating instructions

-6-
(1) Auto Iris Lens Connector
This 4-pin connector supplies the power and DC
control signal to the auto iris lens.
(2) Flange-back Adjusting Ring
This ring is used to adjust the back focal length or
picture focus by rotating this ring.
(3) Lens (Option)
See page 11, 12, 13, 14 and 15 for details on lens
selection. Standard C-mount lens can be used
with the camera by use of optional lens mount
converter (C-mount adaptor) WV-AD20.
(4) Camera Mounting Screw Hole
This threaded hole (1/4" - 20) is used to mount the
camera onto a mounting bracket or tripod.
(5) Video Output Connector (VIDEO OUT)
A 1.0 V[p-p] / 75Ω composite video signal is pro-
vided at this connector.
Whenever the multiplexed vertical drive (VD2) sig-
nal is supplied to this connector, the camera syn-
chronization mode is automatically set to Vertical
Drive Lock.
(6) AC Power Cord
(7) Sync Selection Switch (LL/INT)
(WV-CP220/WV-CP224)
This switch is used to select the camera synchro-
nization mode.
INT: The camera synchronization mode is set to
internal 2 : 1 interlace.
LL: The camera synchronization mode is set to
Line-lock.
(8) Electronic Light Control/Automatic Light
Control Selection Switch (ELC / ALC)
This switch is used to select the lens as follows.
ALC: Choose this position when using an auto iris
lens.
ELC: Choose this position when using a fixed or
manual iris lens.
(9) Detail level Selection Switch (SOFT/SHARP)
The detail/aperture level can be selected by this
switch. Set the switch to the desired position while
observing the picture on the monitor.
Note: Usually set this switch to SHARP position.
When Quad System is connected to this cam-
era, set this switch to SOFT position.