User Manual

RJ11 Modular Cable Test

Please follow directions for the UTP/STP Cable Test anduse the

operations manual for the correct LED pin out display

Coaxial Cable Test

1.Plug the two attached BNC adapter cables on both RJ45 jacks.

Then connect the tested cable to each end of the BNC adapter

cables

2. For the remaining testing procedures, please refer to 10Base-T

Test steps 2 to 5.

Note:

1. The center pin of BNC should be read on LED 2.

2. As Coaxial cable has only two wires, we suggest you read the

result of the LED scan using Manual mode.

Remote Test

1. Plug one end of the tested cable to the transmitting RJ45 jack on

the master unit marked with a ' ' and plug the other end into the

remote terminator. If the tested cable is installed in a patch panel

or wall plate, you may use the included patch cable to solve the

connector gender problem.

2. Now, set the Auto/Manual switch to Auto mode for

one-persontesting.

3. Read the test results from the LED display on remote terminator.

Note: The LED display on the remote unit will scan in

sequencecorresponding to the transmitting end of the master

unit.