Information

For technical assistance in the U.S., call 866-405-6654 (outside the U.S., see inside back cover for directory)
ELECTRICAL SOLUTIONS
C1.49
B2.
Cable
Accessories
C1.
Wiring
Duct
C3.
Abrasion
Protection
C4.
Cable
Management
D1.
Terminals
D2.
Power
Connectors
E1.
Labeling
Systems
E2.
Labels
E3.
Pre-Printed
& Write-On
Markers
F.
Index
B3.
Stainless
Steel Ties
C2.
Surface
Raceway
E5.
Lockout/
Tagout
& Safety
Solutions
B1.
Cable Ties
A.
System
Overview
D3.
Grounding
Connectors
E4.
Permanent
Identification
Installation Tips:
Application of Latex Paint on Panduct
®
Wiring Duct
Cutting Wiring Duct and Cover
Recommended Precaution when Using Type NNC and NE Wiring Duct
The following is recommended to properly prepare the surface of the
wiring duct/raceway and covers for the best adhesion of latex paint:
1. Clean surface with mild soap and water solution or mineral spirits
with a clean lint free towel. Allow to dry.
2. Using a sanding pad (such as synthetic stripping pad or medium/fine
steel wool), slightly roughen the surface to be painted.
3. Apply a coat of all-purpose 100% acrylic primer and allow to dry.
4. Apply the desired topcoat of latex paint and allow to dry.
5. Install the wiring duct/raceway and covers.
For small quantities, use the DCT duct cutting tool on page C1.34. For larger quantities use a miter cutting
saw blade for clean burr-free cuts. Recommended blade:
Carbide 80T or 100T; .90" thickness, .125 kerf.
Cleaning solvents and cutting fluids that contain any of the following chemical agents should not come in
contact with type NNC or type NE wiring duct. These chemicals are known to cause stress cracking in the
halogen-free PPO material.
• Hydrocarbons
• Phenols
• Ketones
• Amines
• Ethers
• Organic, inorganic and oxidizing acids
• Petrol
Note: Panduit assumes no liability for the accuracy or completeness of this list.
Part Number System for Panduct
®
Wiring Duct
G = Wide Slot
Flush Design
F = Narrow Slot
Flush Design
FL = Flexible Duct
FS = Solid Wall Flush Design
H = Wide Slot Hinged Design
HN = Narrow Slot Hinged Design
HS = Solid Wall Hinged Design
D = Round Hole Flush Design
NNC = Halogen-Free Design
NE = Halogen-Free Wide Slot Design
MC = Metric Narrow Slot Design
LG = Light
Gray
WH = White
BL = Black
IB = Intrinsic Blue
IG = International
Gray
-A = Adhesive Backed
= Without Adhesive
(leave blank)
NM = No Mounting Holes
In. or mm
Ft. or m
G.5
X
.5 LG 6 -A
Type
Nominal Width
Nominal Height Color Length
In. or mm