Information

ELECTRICAL SOLUTIONS
Order number of pieces required, in multiples of Standard Package Quantity.
Prime items appear in BOLD.
C2.60
B2.
Cable
Accessories
C1.
Wiring
Duct
C3.
Abrasion
Protection
C4.
Cable
Management
D1.
Terminals
D2.
Power
Connectors
E1.
Labeling
Systems
E2.
Labels
E3.
Pre-Printed
& Write-On
Markers
F.
Index
B3.
Stainless
Steel Ties
C2.
Surface
Raceway
E5.
Lockout/
Tagout
& Safety
Solutions
B1.
Cable Ties
A.
System
Overview
D3.
Grounding
Connectors
E4.
Permanent
Identification
LDS3
LDS5
LMD3
LMD5
LDS3
Internal Area = .21 Sq. In.
LDS5
Internal Area = .38 Sq. In.
Method for Bending Type LDS Raceway (Low Voltage Applications)
1) Slide 18" to 30" section of LDS Raceway
into PVC pipe heating blanket.
*(Recommended blanket designed for
bending 1/2" to 1 1/2" PVC conduit.)
2) Allow section to heat approximately
2 – 3 minutes. Raceway will be soft and
pliable, but should not stretch. (Time
will vary with blanket temperature
and raceway size.)
3) Remove raceway section from blanket
and hold in desired position until the
raceway cools. Install mounting
straps immediately.
*Heating blanket not offered by Panduit .
Pan-Way
®
LDS Surface Raceway System
• UL and CSA rated 600 V; meets UL 5A and CSA C22.2
No. 62.1-03 standards; FT4 rated
• Tamper resistant non-hinged design
• Factory applied adhesive backing speeds installation
• Type LDS is the only non-metallic raceway that is bendable in
low voltage applications to route around and over obstructions
• LDS raceway requires screw mounting using the LMD mounting
straps for power cabling installations
• Terminates using surface mount outlet box solutions or
Panduit
®
Mini-Com
®
Surface Mount Boxes
‡For other colors replace IW (Off White) with EI (Electric Ivory), IG (International Gray), or WH (White).
Order number of feet required in multiples of standard length increments.
Part Number Part Description Raceway Size Color‡
Length
(Ft.)
Std.
Ctn.
Qty.
LDS3 – Surface Raceway
LDS3IW10-A
Tamper resistant one-piece surface
raceway. Supplied with pre-applied
adhesive backed tape. Available in
10' lengths.
.77" x .41"
(20.0mm x
10.4mm)
Off
White
10 200
LDS5 – Surface Raceway
LDS5IW10-A
Tamper resistant one-piece surface
raceway. Supplied with pre-applied
adhesive backed tape. Available in
10' lengths.
1.01" x .55"
(26.0mm x
14.0mm)
Off
White
10 200
Mounting Straps
LMD3IW-Q
For use with LDS3 raceway. Size 3 Off
White
— 100
LMD5IW-Q
For use with LDS5 raceway. Size 5 Off
White
— 100