Installation Manual

For Technical Support: www.panduit.com/resources/install_maintain.asp
INSTALLATION INSTRUCTIONS
© Panduit Corp. 2015
FS006D
Page 10 of 11
Bend radius
control clip
Plunger and
grommet
Figure 10A
Sliding tray
flange
Plunger and
grommet
Slide bend radius control clip over sliding tray
flange as shown. Push plunger/grommets
through bend radius control clip and sliding
tray flange hole. Fully seat plunger into
grommet to secure the clip. Repeat for the
other side.
Bend radius
control clips
Plunger and
grommet
Figure 10
Figure 11
Patch Cord Bend Radius Control Clip Installation
Install patch cords into FAPs/cassettes routing
through bend radius control clips and
maintaining proper patch cord bend radius.