Installation Manual

For Technical Support: www.panduit.com/resources/install_maintain.asp

INSTALLATION INSTRUCTIONS

FS006D

Page 3 of 11

Figure 5A

After the enclosure is mounted to the rack, determine

the size of the innerduct that will be used to bring the

cable into the enclosure. Prepare grommet(s)

according to the proper cutting diagram to the left.

Install the strain relief bracket near where the cable will

enter the enclosure. Secure with #10-32 x 3/8" screw

and #10-32 hex nut.

Strain relief

bracket

#10-32 x 3/8"

screw

#10-32 hex

nut

Note: Cover not shown for clarity.

Figure 5

Figure 6

Install grommets as desired.

Cut out the small

circle for 1-1/4" dia.

innerduct

Cut out the large circle

for 1-1/2" dia.

innerduct

Cut the straight lines

when not using any

innerduct

Cut out the small

circle for 1" dia.

innerduct

Cut the straight

lines for smaller

bundle sizes

Grommet Cutting Diagram