Installation Manual

For Technical Support: www.panduit.com/resources/install_maintain.asp

INSTALLATION INSTRUCTIONS

FS006D

Page 6 of 11

Place slack spools over #10-32 studs on sliding

tray. Secure with #10-32 hex nuts and/or adhesive

mounts (make sure to punch hole into adhesive

mounts). Note spool orientation.

Position FAPs between upright flanges as shown.

Once mounted, fully seat NyLatch fasteners to

secure FAPs.

Slack spools

Field Termination or Pre-Terminated Trunk Installation

Fully extend drawer to ensure proper amount of

slack is used.

Top view, cover not shown for clarity.

Please note orientation of spools.

Fiber Adapter Panels (FAPs):

Up to 4 for FEC1U & FCE1UA

Up to 8 for FCE2U

Figure 8

Figure 8A

Drawer shown fully extended

and tilted downward

(cables omitted for clarity)