Component Guide

Data Center Roadmap Details
(See Roadmap on pages 4 and 5.)
A. Routing Cable Out of the MDA
The FiberRunner
®
Cable Routing System includes vertical tee fittings for
routing cables out of the MDA racks. These fittings can be sized for the
anticipated cable capacity and positioned directly above the vertical cable
managers to create as direct a pathway as possible.
Components used in this detail:
1. FRVT12X4 Vertical Tee 4. FRTR6X4 3-Sided Bend Radius
2. FRBC12X4 QuikLock
™
Coupler Control Trumpet
3. FR12X4 Channel 5. FRBC6X4 QuikLock
™
Coupler
B. Transitioning Cables Into the EDA Cabinets
The FiberRunner
®
Cable Routing System offers a wide variety of spill-out
options to provide safe, accessible transitions to the cabinets in the EDA.
Spill-over fittings, which can be attached to any straight section of channel,
can be used at the initial installation or retrofit into existing configurations
as the network changes or grows.
Components used in this detail:
1. FRSP Spill-Over Junction 4. FIDT2X2 Transition to 1.5''
2. FR6X4 Channel ID Slit Corrugated LoomTubing
3. FBC2X2 QuikLock
™
Coupler 5. CLT150F 1.5'' ID Slit
Corrugated Loom Tubing
C. Transitions to Other Channel Sizes
Reducer fittings are available to provide a method of transitioning between
different FiberRunner
®
Cable Routing System sizes. In addition, 12x4 tee
fittings and 4-way crosses with integral 6x4 exits can be used to create
feeder runs.
Components used in this detail:
1. FRBC12X4 QuikLock
™
Coupler 6. FRBC4X4 QuikLock
™
Coupler
2. FR12X4 Channel 7. FRBC6X4 QuikLock
™
Coupler
3. FRFWC12X4W6 4-Way Cross 8. FR6X4 Channel
with 6x4 Exits 9. FRRF126R 12x4 to 6x4
4. FRRF6FR4 6x4 to 4x4 Transition Right Reducer Fitting
Reducer Fitting
5. FR4X4 Channel
6
1
2
3
4
5
1
2
3
4
5
1
9
7
8
2
3 4
5
6