User Manual
Table Of Contents
- PanTher™ LS8EQ
- Hand-Held Thermal Transfer Printer
- Operator’s Manual
- Section 1: Getting Started 3
- Introduction and Safe Operation 4-6
- General Description 7-8
- Loading Batteries and Label Cassette 9
- Keyboard Functions 10-11
- Creating Labels
- Creating Serializations 16-18
- Setting up the PanTher™ LS8EQ and Using File Manager 31-33
- Printer Cleaning Instructions 63-64
- Warranty Information ….. 69
- General Specifications 70
- Global Technical Support Information 71
- Batteries
- Replace All Six Batteries At The Same Time
- A01 A01 A02 A02 A03 A03
- A01 A02 A03 A01 A02 A03
- A01
- A01 A02
- A01
- A01
- A01
- A01
- A01 A02 A03 A04 A05 A06
- WARNING
- WARNING
- The Setup Menu
- The setup menu is used to modify the default printer settings. The setup menu should be accessed from the home screen. To access the setup menu press the SETUP key.
- Heat Shrink Serialization…
LOADING BATTERIES AND LABEL CASSETTE
Loading the Batteries
1. Remove the battery door from the back of the PANTHER LS8EQ printer. If
the impact bumper is installed on the printer, you will have to move it away
from the battery door first.
2. Install the 6 AA batteries according to the molded indicators within the battery
compartment.
3. Reattach the battery door. Move the impact bumper back over the battery
door if necessary.
Observe Correct Polarity When Installing
Batteries
Replace All Six Batteries At The Same Time
Loading a Label Cassette
1. Remove the cassette door from the back of the PANTHER LS8EQ printer.
2. Install a label cassette. Press firmly to lock the cassette in place. Do not
remove the raised white tab from the cassette. This tab is used to assist with
removal of the cassette from the LS8EQ printer.
3. Lock the print head latch.
4. Reattach the cassette door.
NOTE: To uninstall a label cassette:
1. Unlock the print head latch.
2. Remove the cassette door.
3. Remove the cassette. Use the white removal tab on the
cassette for assistance.
4. Reattach the cassette door.
Print Head Latch
10