Installation Manual

INSTALLATION INSTRUCTIONS
© Panduit Corp. 2017
E-mail:
[e-mail]
Phone:
866-405-6654
For Instructions in Local Languages
and Technical Support:
www.panduit.com/resources/install_maintain.asp
Page 1 of 1
www.panduit.com
NK397D
NetKey
Network Components
Keystone Cabling System
NetKey Keystone Solder Type AV Modules
Part Numbers: NKRSMB**Y, NKRSMR**Y, NK35MSS**
STEP ONE
A. SLIDE SOLDER RING, LOCKWASHER, AND NUT
ONTO SIGNAL WIRE.
B. PULL SIGNAL WIRE THROUGH MODULE.
C. LOOP WIRE THROUGH HOLE IN RCA AND TWIST.
D. SOLDER WIRE TO BACK OF RCA.
STEP TWO
A. ASSEMBLE SOLDER RING, LOCKWASHER, AND
NUT TO RCA-MODULE SUBASSEMBLY.
B. LOOP GROUND WIRE THROUGH SMALL HOLE IN
SOLDER RING AND TWIST.
C. SOLDER GROUND WIRE TO SOLDER RING.
STEP THREE
A. BEND SOLDER RING TAB 90°.
SOLDER RING
LOCKWASHER
NUT
90°
A. REFER TO FIG. 1 FOR WIRE PLACEMENT.
B. SOLDER WIRES TO CORRECT TABS ON THE BACK
OF CONNECTOR.
GROUND WIRE
Fig. 1
TIP (L)
SLEEVE
RING (R)
RCA Modules
3.5mm(1/8") Stereo Modules
(Ground)
- long pin
- gold pin
(NKRSMB**Y, NKRSMR**Y)
(NK35MSS**)