Installation instructions

INSTALLATION INSTRUCTIONS NK194B

For Technical Support: www.panduit.com/resources/install_maintain.asp

NETKEY

NETWORK COMPONENTS

CONTRACTOR GRADE

Page 1 of 2

TERMINATION INSTRUCTIONS

Signal Ground

RCA Module

S-Video Module

Chrominance

Chrominance Ground

Luminance Ground

Luminance

Remove approximately 1" of cable jacket. (CAUTION: Do not damage conductors.) Fan out twisted pairs for

termination.

S-Video Module RCA Module

STEP 1

Use the PDT110 Single Wire Punchdown tool to punchdown conductors in the orientation shown.

Modules should appear as shown below when terminated.

Signal

STEP 2

Signal and Signal Ground use one twisted pair

Chrominance and Chrominance Ground use one twisted pair

Luminance and Luminance Ground use one twisted pair

NETKEY RCA and S-Video

110 Style Punchdown Modules

Part Numbers: NKSPM**, NKRPM***, NKSPB

(UTP Cable)

White / Blue

Blue

White / Orange

Orange

PAGE 1
NETKEY NETWORK COMPONENTS NETKEY RCA and S-Video 110 Style Punchdown Modules CONTRACTOR GRADE Part Numbers: NKSPM**, NKRPM***, NKSPB INSTALLATION INSTRUCTIONS © Panduit Corp. 2007 NK194B TERMINATION INSTRUCTIONS STEP 1 Remove approximately 1" of cable jacket. (CAUTION: Do not damage conductors.) Fan out twisted pairs for termination. STEP 2 Use the PDT110 Single Wire Punchdown tool to punchdown conductors in the orientation shown.
PAGE 2
INSTALLATION INSTRUCTIONS NK194B STEP 3 Install the P110RC2 wire retention cap onto the connector block. Modules should appear as shown below when completed. RCA Module S-Video Module OPTIONAL STEP Screwdriver Slot Use the optional NKSPB NETKEY 110PD Module Puck to align and hold the module for termination to the connector block. Set fully assembled Module into puck, aligning Flexible snap on module with screwdriver slot on puck. Snap in place. Do not press on the connector to snap in place.