User Manual
For Technical Support: www.panduit.com
INSTALLATION INSTRUCTIONS
©PanduitCorp.2022
PN616C
TABLE LEG
3-1/4”
MEASURE
TABL E
HEIGHT
Raceway
Cover
1
Center of table leg transition fitting will sit approximately 3-1/4" from the edge of the raceway cover.
Route cables prior to installing the raceway cover.
NOTE: Desired hole in table should be offset from table leg center to accommodate proper
mounting of table leg.
T
O•
P
Made in PVC
03
USA
FT4
SUR FACE NONME TALLIC R ACE WA Y
68YL
600V MAX
2
Measure the height
from the floor to the
underside of the table.
Channel should be
between 3-1/2" to 4"
shorter than the mea-
sured height. If neces-
sary, cut channel from
bottom edge to accom-
modate.
INSTALLATION BETWEEN 2 RACEWAY CHANNELS
Page 7 of 15