Installation Manual

B20250 Rev.2 GMPSL-INV B20250 Rev.2 GMPSL-INV

ASSEMBLY INSTRUCTIONS FOR ASSEMBLY INSTRUCTIONS FOR

GATE VALVE LOCK-OUT GATE VALVE LOCK-OUT

Figure A

Figure B

Figure A

1.) Close valve and verify

energy is isolated

2.) Cover valve handle with

PSL-V lockout of

corresponding size.

Figure B

1.) Close PSL-V lockout

and install lock.

Figure A

1.) Close valve and verify

energy is isolated

2.) Cover valve handle with

PSL-V lockout of

corresponding size.

Figure B

1.) Close PSL-V lockout

and install lock.

Figure A

Figure B

PAGE 1
ASSEMBLY INSTRUCTIONS FOR GATE VALVE LOCK-OUT ASSEMBLY INSTRUCTIONS FOR GATE VALVE LOCK-OUT Figure A Figure A Figure A Figure A 1.) Close valve and verify energy is isolated 2.) Cover valve handle with PSL-V lockout of corresponding size. Figure B 1.) Close valve and verify energy is isolated 2.) Cover valve handle with PSL-V lockout of corresponding size. Figure B Figure B B20250 Rev.2 Figure B 1.) Close PSL-V lockout and install lock. 1.) Close PSL-V lockout and install lock.
PAGE 2
Figure C Figure C Figure C Figure C 1.) If needed, cut the recessed section with a knife to make clearance for the valve stem. 1.) If needed, cut the recessed section with a knife to make clearance for the valve stem. Cut Here Figure D Figure D 1.) For small valves using PSL-V2A Only 2.) Drill a hole aligned with hole created as in Figure C 3.) Close the lockout completely and install lock Drill Here For more information Visit us at www.Panduit.com Contact Customer Service by email: cs@panduit.