Installation Manual

For Technical Support: www.panduit.com/resources/install_maintain.asp

INSTALLATION INSTRUCTIONS

PN638

Page 1 of 2

EASY PAYOUT PACKAGING FOR COPPER CABLE

REELEX

SYSTEM PACKAGING

Handling, Payout and Use

Orientation Packages should be orientated so that the payout hole faces the direction the

product is being pulled from.

DO NOT dispense the product with the coil in the horizontal position as this may

cause tangling. Make sure the coil is always upright.

Losing the End If the product falls back into the hole, the installer should access the inside

diameter of the coil though the access panel, or by opening the package and

thread the inside end back through the payout tube.

Resolving Tangles If a tangle or snag does occur, often it is caused by improper box size or opera-

tor error when packaging.

Most tangles can be resolved by accessing the inside of the coil through the

access panel or by opening the package. Make sure the inside layers of the coil

are not getting in the way of the product paying out. If a knot does occur, either

resolve it inside the package, or try to pull it through (only on REELEX

II).

Handling, Palletizing and Shipping

Orientation Packages should be placed on a pallet with the coils upright. If the packages

are placed horizontally, the product inside can come out of place and cause

knots or tangling.

When stacking packages on the pallet, take a look at which direction the flutes

(or grooves) in the cardboard go. To prevent crushing, these flutes must be

vertical to provide support for the next layer.

D-2000 boxes are slightly different in design compared to standard

REELEX

II boxes. Boxes designed for the D-2000 have exposed flaps where

the panels are glued together. When stacking these boxes on a pallet, stack

each layer 180-degrees from the layer below so that the glue flaps interlock (bot-

tom left). This method adds stability when shipping.

Overhang Do not allow the packages to overhang the pallet as the product could become

damaged.

PAGE 1
EASY PAYOUT PACKAGING FOR COPPER CABLE REELEX® SYSTEM PACKAGING INSTALLATION INSTRUCTIONS © Panduit Corp. 2019 PN638 Handling, Payout and Use Orientation Packages should be orientated so that the payout hole faces the direction the product is being pulled from. DO NOT dispense the product with the coil in the horizontal position as this may cause tangling. Make sure the coil is always upright.
PAGE 2
INSTALLATION INSTRUCTIONS © Panduit Corp. 2019 PN638 Standard REELEX® (Small Payout Tube) Palletizing Paperboard flute direction must be vertical when stacked. REELEX® II (Large Payout Tube) Palletizing Fold-Tab Boxes (Hand-Packed) Paperboard flute direction must be vertical when stacked. K OK O Glued Boxes (Assembled on D-2000) Paperboard flute direction must be vertical when stacked. REELEX® is a registered trademark of REELEX® Packaging Solutions, Inc.