Installation Manual

INSTALLATION INSTRUCTIONS

For Technical Support: www.panduit.com/resources/install_maintain.asp

CM599L

Page 10 of 27

[6] Grounding Lug Locations

(Front and Rear of Beams)

Grounding

• Attach Grounding Lug or Grounding Bar to Common Bonding Network (CBN) at any of the [6] location(s) shown below

• Grounding location is indicated by universal ground symbol near grounding lug locations

• Remove factory-installed masking tape at grounding lug location to expose unpainted surface of cabinet frame. Grounding lug or

grounding bar must assembled onto this unpainted surface (per NEC NFPA 70 Article 250.12)

• Use [2] M5 bonding screws to fasten grounding terminal to cabinet frame (torque screws to 5.1 N-m (45 in-lb)

Note: top cap removed for clarity.

Masking Tape

ELECTRICAL SHOCK HAZARD

Each cabinet must be connected to the Common Bonding Network (CBN).

FAILURE TO FOLLOW THESE INSTRUCTIONS CAN LEAD TO SERIOUS INJURY, DEATH, OR DAMAGE TO YOUR EQUIPMENT.

DANGER