Installation Manual

Page: 1 of 2
Heat Trace
Installation Instructions
PA27801A01
Rev. 00 12-2015
Using ST2MT or ST4MT Installation Tools
© Panduit Corp. 2015
Safety glasses must be worn at all times by all persons within ten (10) feet of working metal tie
installation tool. CAUTION: Be aware of the ejection of metal cable tie scrap from tool.
Safety gloves must be worn while applying metal ties using this tool.
DO NOT use tool on live electrical sources.
DO NOT place fingers near gripper during tool actuation. Fingers may be pinched by moving gripper.
1. Determine minimum acceptable required length for Heat Trace Wave-Ty
• Nominal pipe diameters are based on either inside diameter (ID) or outside diameter (OD); and there
are a number of schedules available throughout the internet.
• ID is used for pipes sized from 0 – 12 inches. Greater than 12 inch pipe is typically measured in terms
of OD.
• The Panduit Heat Trace Wave Ty can cover pipes ranging from 1 inch up to 36 inches.
2. Use look up table for pipe diameters and Heat Trace Wave Ty part numbers.
HTMLT Tie
Pipe Diameter
Part Number
Width (in.)
Length (in.)
ST2MT/ST4MT Tools
Std. Pkg.
Qty.
HTMLT2.7WEH-LP
0.50
10.2
1.0
50
HTMLT4WEH-LP
0.50
14.3
2.0
50
HTMLT6WEH-LP
0.50
20.5
3.0, 4.0
50
HTMLT8WEH-LP
0.50
26.8
6.0
50
HTMLT10WEH-LP
0.50
33.0
7.0, 8.0
50
HTMLT12WEH-Q
0.50
42.2
9.0, 10.0
25
HTMLT16WEH-Q
0.50
54.8
11.0, 12.0, 14.0
25
HTMLT26WEH-Q
0.50
86.2
16.0, 20.0, 24.0
25
HTMLT38WEH-Q
0.50
123.9
26.0 - 36.0
25
If you have a pipe diameter that is not listed on the table, move to the next highest size;, i.e., 5 inch pipe
diameter. This would require the use of the HTMLT8WEH-LP for the ST2MT/ST4MT tool
3. Once you have selected the right size Heat Trace Wave Ty, go to actual onsite installation. For purposes
of installing heat trace, first position heat trace against the pipe.