Thermal Transfer Printer OPERATOR MANUAL TDP42H, TDP43H, TDP46H

1 2 3 4 5 6 7 8
1 2 3 4 5 6 7 8
1 2 3 4 5 6 7 8
PANDUIT TDP4*HGMTDPH-MAN
Page 3-4
Section 3: Configuration
Firmware Download (DSW2-6). Places the printer in the Firmware Download mode for downloading new
firmware into flash ROM.
Protocol Code Selection (DSW2-7). Selects the command codes used for protocol control. Refer to page E-1
for more information.
Status Select (DSW2-8). For emulating earlier series software commands. Should be used only if problems
are encountered when using existing software. This switch will also affect the settings selected by DSW1-7 and
DSW1-8.
Backfeed Sequence (DSW3-1, DSW3-2). Backfeed is used to correctly position the label for application and
then retract the next label to the proper print position. This operation can be performed immediately after a
label is printed and used, or immediately prior to the printing of the next label.
DSW2
ON
OFF
DSW2-6 SETTING
Off Disabled
On Enabled
DSW2
ON
OFF
DSW2-7 SETTING
Off Standard
On Non-Std
DSW2
ON
OFF
DSW2-8 SETTING
Off Status 3 & 4 Enabled
On Status 2 & 3 Enabled
1 2 3 4 5 6 7 8
DSW3
ON
OFF
DSW3-1
Off Off
Off On
SETTING
Continuous
Tear-Off
On Off Cutter*
On On Not Used
* Defaults to continuous if cutter not installed