Thermal Transfer Printer OPERATOR MANUAL TDP42H, TDP43H, TDP46H

PANDUIT TDP4*H GMTDPH-MAN
Page 3-23
Section 3: Configuration
This selection specifies whether or not the printer will print the last
printed label stored in memory when the FEED key is pressed in
the Normal Online mode.
1. Use the LINE key to step the cursor to desired setting. If Yes is
selected, the printer will reprint the last label when the FEED key
is pressed when the printer is Online. If the printer is Offline,
pressing the FEED key will feed a blank label.
2. Once the setting is correct, pressing the FEED key will accept
the setting and advance to the
REPRINT W/FEED
YES NO
This display will only appear Backfeed is enabled (DSW3-4 = OFF).
The maximum backfeed distance is 255 mm.
1. Use the LINE key to select either the Default or the Manual
selection.
2. Once the setting is correct, pressing the FEED key will accept
the setting and advance to the next display.
3. If Manual setting is selected, use the Cursor keys to advance the
distance to the desired setting. Each time the LINE key is
pressed, the Distance will advance 1 mm. The maximum
distance is 255 mm.
4. Once the desired distance is set, press the FEED key to accept
the setting and step to the next display.
FORWARD/BACKFEED
DISTANCE DEFAULT
FORWARD/BACKFEED
DISTANCE XXXmm
This selection allows the user to select the conditions that cause the
signal on Pin 9 of the EXT connector to be true. If Mode1 is
selected, pin 9 will be true when the printer is ready to print, i.e. it is
Online and has a print job loaded (a quantity of labels to be printed
on the display). If Mode 2 is selected, pin 9 will be true if the printer
is Online.
1. Use the LINE key to step the cursor to the desired setting.
2. Once the desired setting is selected, press the FEED key to
accept the setting and step to the next display.
EXT PIN 9 SELECT
MODE1 MODE2
This selection allows the user to specify the dexadecimal code for
the character which is replaced with the Euro Character. The default
is D5H.
1. The cursor should be positioned over the first digit selection. Use
the LINE key to step to the desired setting.
2. Press the FEED key to advance the cursor to the second digit of
the desired hexadecimal code.
3. Press the LINE key to step to the desired setting.
4. When the setting is correct, press the FEED key to accept the
setting and step to the next display.
EURO CODE
D5