Installation Manual

WGSDWL

(WGSDWL6Shown)









1









2





For Use With PANDUIT

Wyr-Grid Cable Routing

System

Wyr-Grid Sidewall and Intersection

Bend Radius Control



Panduit Part Numbers: WGSDWL2**, WGSDWL4**, WGSDWL6**, WGINTBRC2**. WGINTBRC4**, WGINTBRC6**

INSTALLATION INSTRUCTIONS

For Technical Assistance, Call: 800-777-3300



PAGE 1
For Use With PANDUIT Wyr-Grid Cable Routing System Wyr-Grid Sidewall and Intersection Bend Radius Control Panduit Part Numbers: WGSDWL2**, WGSDWL4**, WGSDWL6**, WGINTBRC2**. WGINTBRC4**, WGINTBRC6** INSTALLATION INSTRUCTIONS © 2010 PANDUIT Corp.
PAGE 2
INSTALLATION INSTRUCTIONS 1 A B C D WGINTBRC (WGINTBRC6 Shown) Figure 1.) Begin by sliding Snap‐On Component A to the outer edge of the bend radius control grid. Next, position Snap‐On component A over the second sidewall opening on pathway C, which aligns Snap‐On Component B over the sidewall of pathway D. Last, slide Snap‐On Component B along the bend radius control grid until it is aligned with an available sidewall opening on pathway D.