User Manual

30
（4） Estimate the offset from the nozzle to the print bed, take the print bed as zero
point, if the nozzle is higher than the bed, the offset is a positive value, and if the
nozzle is pressing the bed, the offset is a negative value.
（5） For example, the nozzle is 0.3mm far away from the print bed after Z Axis
homing, so the offset value should set to be 0.3. Click the “Z offset” button on the
console, and input the value “0.3” to the input box, then click “” button to save.
Positive Offset（+） Zero Offset（0） Negative Offset（-）
0.3mm