User Manual

31
（6） The printer will auto home Z Axis, and move down 0.3mm to compensate the
offset. If the value is proper, the nozzle will exactly hit the print bed. But if not, you
can adjust the value and try more times until you get a good result.
6. Feed the filament
（1） Click the “Heat E” button and wait until the nozzle temperature reach preset
value (200 C).
（2） Cut the end of filament into speculate shape, press the lever on the Extruder,
and insert the filament into the feed hole on the top, manual extrude the filament to
make it go out from the nozzle.