Panowin F1 Heated Bed Platform (HBP) Instruction 磐纹科技(上海)有限公司
Package list 3M sticker HBP Cable Spacer Zip tie Steps: 1.
2. Put the spacer on the sliding module of Y axis; 3. Connect the short end of the cable with the HBP as picture shows.
. Use the zip tie to lock the cable with the HBP; 5. Remove the rest of the zip tie and make sure the cable is fixed; 6.
7. Lock the HBP with flat screws; 8.
9. Connect the longer side of the cable with the 4 pin port on the PCB controller; 10.
11. Stick the sticker on the HBP and make sure the surface is flat; 12. The LED light on the bottom shows the working condition of the HBP. Power 13. Temperature There maybe a little offset between the nozzle and the platform after the installation. Please adjust the nozzle height before print.