User's Manual

118/125
Additional information on Specific Absorption Rates (SAR) can be found on the Cellular Telecommunications
Industry Association (CTIA) website at http://www.wow-com.com
.
* In the United States and Canada, the SAR limit for mobile phones used by the public is 1.6 watts/kg (W/kg)
averaged over one gram of tissue. The standard incorporates a substantial margin of safety to give
additional protection for the public and to account for any variations in measurements.
SAFETY INFORMATION FOR BATTERY USAGE
z Do not disassemble or open crush, bend or deform, puncture or shred.
z Do not modify or remanufacture, attempt to insert foreign objects into the battery, immerse or
expose to water or other liquids, expose to fire, explosion or other hazard.
z Only use the battery for the system for which it is specified.
z Only use the battery with a charging system that has been qualified with the system per this
standard. Use of an unqualified battery or charger may present a risk of fire, explosion,
leakage, or other hazard.
z Do not short circuit a battery or allow metallic conductive objects to contact battery terminals.
z Replace the battery only with another battery that has been qualified with the system per this
standard, I EEE-Std-1725-2006. Use of an unqualified battery may present a risk of fire,
explosion, leakage or other hazard.
z Promptly dispose of used batteries in accordance with local regulations
z Battery usage by children should be supervised.
z Avoid dropping the phone or battery. I f the phone or battery is dropped, especially on a hard
surface, and the user suspects damage, take it to a severe center for inspection.
z Improper battery use may result in a fire, explosion or other hazard.
FCC & INDUSTRY CANADA REGULATORY
COMPLIANCE
FCC & Industry Canada Regulatory Compliance
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)
this device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Your mobile device is a low power radio transmitter and receiver. When it is ON, it receives and also sends
out radio frequency (RF) signals. In August 1996, the Federal Communications Commission (FCC) adopted
RF exposure guidelines with safety levels for mobile devices. Those guidelines are consistent with safety
standards previously set by both U.S. and international standards bodies: American National Standard
Institute (ANSI), National Council of Radiation Protection and Measurements(NCRP), and International
Commission on Non-Ionizing Radiation Protection (ICNRP). Those standards were based on comprehensive
and periodic evaluations of the relevant scientific literature. The design of your phone complies with the FCC
guidelines and applicable.
Statement according to FCC part 15.105
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful