Operation Manual

INSTALL BATTERY

1. Insert your ngernail into the slot(1), then push down on

top of the battery cover and slide it o to remove (2).

2. Slide the battery into the slot (3) by aligning the contacts

and push down (4) until you hear the “click”.

3. Align the cover tabs with the slots on the back of the

device and slide the battery cover onto the unit until it

snaps into place.

If the battery is not correctly placed in the compartment, the handset will not turn on

and/or the battery may detach during use.

Correct Incorrect

REMOVE BATTERY

1. To remove the battery cover, insert your ngernail into

the slot(1), then push down on top of the battery cover

and slide it o (2).

2. Insert your ngernail into the slot (3) and lift the battery

from the compartment (4).

3. Align the cover tabs with the slots on the back of the

device and slide the battery cover onto the unit until it

snaps into place.

CHARGING YOUR BATTERY

1. To Charge, connect the wall charger. Make sure you

align the connector as shown in the image.

2. Plug the wall charger into an electrical outlet.

If the battery connector is not properly aligned, damage

could occur to the charging connector and the phone may

not charge.

Correct Incorrect