Operation Manual

SAR INFORMATION
as described in this user guide, is 0.633 W/kg. (Body-worn mea-
surements differ among phone models, depending upon available
accessories and FCC requirements). While there may be differ-
ences between the SAR levels of various phones and at various
positions, they all meet the government requirement for safe expo-
sure.
The FCC has granted an Equipment Authorization for this model
phone with all reported SAR levels evaluated as in compliance with
the FCC RF exposure guidelines. SAR information on this model
phone is on file with the FCC and can be found under the Display
Grant section of http://www.fcc.gov/oet/fccid after searching on FCC
ID PP4TX-60B.
Additional information on Specific Absorption Rates (SAR) can be
found on the Cellular Telecommunications & Internet Association
(CTIA) web-site at http://phonefacts.net.
* In the United States and Canada, the SAR limit for mobile phones
used by the public is 1.6 watts/kg (W/kg) averaged over one gram
of tissue. The standard incorporates a substantial margin of safety
to give additional protection for the public and to account for any
variations in measurements.
“The highest reported SAR values of this model are:
AMPS/CDMA modes - head: 1.21 W/Kg, Body-worn: 0.473 W/Kg.
PCS/CDMA modes - Head: 1.13 W/Kg, Body-worn: 0.337 W/Kg”
Chapter 11 - Page 135
THIS MODEL PHONE MEETS THE GOVERNMENT’S
REQUIREMENTS FOR EXPOSURE TO RADIO WAVES.
Your wireless phone is a radio transmitter and receiver. It is
designed and manufactured not to exceed the emission limits for
exposure to radiofrequency (RF) energy set by the Federal
Communications Commission of the U.S. Government. These lim-
its are part of comprehensive guidelines and establish permitted
levels of RF energy for the general population. The guidelines are
based on standards that were developed by independent scientific
organizations through periodic and thorough evaluation of scientific
studies. The standards include a substantial safety margin
designed to assure the safety of all persons, regardless of age and
health.
The exposure standard for wireless mobile phones employs a unit
of measurement known as the Specific Absorption Rate, or SAR.
The SAR limit set by the FCC is 1.6 W/kg.* Tests for SAR are con-
ducted with the phone transmitting at its highest certified power level
in all tested frequency bands. Although the SAR is determined at
the highest certified power level, the actual SAR level of the phone
while operating can be well below the maximum value. This is
because the phone is designed to operate at multiple power levels
so as to use only the power required to reach the network. In gen-
eral, the closer you are to a wireless base station antenna, the lower
the power output.
Before a phone model is available for sale to the public, it must be
tested and certified to the FCC that it does not exceed the limit
established by the government-adopted requirement for safe expo-
sure. The tests are performed in positions and locations (e.g., at the
ear and worn on the body) as required by the FCC for each model.
The highest SAR value for this model phone when tested for use at
the ear is 1.15 W/kg and when worn on the body,
SAR INFORMATION
Page 134 - Chapter 11