User Manual
Table Of Contents
- Equipment Information
- CE Declaration
- FCC Notice
- Industry Canada Compliance Statement
- Roving Networks RN42
- FCC Regulatory Information
- Limited Warranty
- Proprietary Notice
- Table of Contents
- Introduction
- Getting Started
- Function Screens
- Using the CAPSURE Instrument
- Selecting Samples
- Calibration
- Operation
- Appendices
CAPSURE User Manual
25
Matching a Sample
Make sure the white reference slider is in the storage location and position the CAPSURE on
to the sample as previously explained.
1. Lightly press and hold the Measure button to activate the preview. The area to be
measured is indicated in the preview by the circle.
Three measurement areas are available:
• Small (2 mm aperture)
• Medium (4 mm aperture)
• Automatic/Large (8 mm with automatic multicolor extraction and texture compensation)
2. Adjust the measurement area by pressing on the up or down side of the Navigation control
while lightly holding down the Measure button.
(2 mm) (4 mm) (8 mm)
Note: You can preset your aperture preference in the Settings menu.
3. When you have located the area you wish to measure, press the Measure button firmly. An
audible “camera-click” sound indicates the start of the measurement. A progress bar
appears at the bottom of the display to indicate the measurement status. It is important
that the instrument is held steady for the duration of the measurement.
The closest match is displayed for the measurement from the active fan decks. Refer to the
Setting Menu section earlier in this manual for procedure on activating fan decks.
Measurement area
within circle
Nav. up
or down
Nav. up
or down