User Manual
Table Of Contents
- Equipment Information
- CE Declaration
- FCC Notice
- Industry Canada Compliance Statement
- Roving Networks RN42
- FCC Regulatory Information
- Limited Warranty
- Proprietary Notice
- Table of Contents
- Introduction
- Getting Started
- Function Screens
- Using the CAPSURE Instrument
- Selecting Samples
- Calibration
- Operation
- Appendices
CAPSURE User Manual
28
Matching a Patterned or Multicolored Sample with Color Picker
The Color Picker function is used on patterned, woven or multicolored samples that you wish to
match a specific color from. Up to four colors within your image can be identified. For example,
this can be used if you did not wish to extract individual shades on textured surfaces or textiles
where potential multiple colors may be found.
1. Make sure the aperture is set to the Automatic/Large option. This enables the instrument to
automatically determine if there is more than one color in the measurement area.
2. Take a measurement as described in the Matching a Sample section earlier in this manual.
The initial color displayed in the Match window is the average color across the
measurement area. Once CAPSURE detects a sample containing more than one color, the
Color Picker icon in the function bar begins rotating and an audible tone is heard. The
screen then automatically advances to the Color Picker function. Individual colors are
selected from this screen.
3. Color descriptions for each color can be displayed by pressing on the up or down sides of
the Navigation control. The selected color is highlighted around the circle.
4. Select the desired color by pressing Enter to display details of the match.
Enter
bottom
Nav. up
or down
Nav. up
or
down