User Manual

ManualsBrandsPantum ManualsLaser PrintersCopier Laser Printer All in One Wireless Printer Scanner Mobile Printing in Black and White, Auto Duplex Printing, 32ppm

Table Of Contents

Preface
Legal Notice
Safety Precautions
Precautions
Legal Information
Table of Contents
1. Before Using the Printer
- 1.1.Product series introduction
- 1.2.Supplied Accessories
- 1.3.Product View
- 1.4.Laser Toner Cartridge
- 1.5.Control Panel
  - 1.5.1.Overview of control panel
  - 1.5.2. Function of numeric keyboard
- 1.6. Function of status indicator
- 1.7. Function of power indicator
2. Paper and Print Media
- 2.1.Paper Specification
- 2.2.Special Paper
- 2.3.Non-printing Area and Non-scanning Area
- 2.4.Loading Paper
  - 2.4.1.Loading into the Automatic Feeder Tray
  - 2.4.2.Install manual feed tray
- 2.5. Paper and Manuscript Use Process
  - 2.5.1.Scanning With Tablet
  - 2.5.2. Scan with the automatic document feeder (ADF)
3. Driver installation and uninstallation
- 3.1. How to install Windows printer driver
- 3.2. Mac system driver installation
  - 3.2.1.Driver installation
- 3.3.Add printer to Mac system
4. Wired network setup (applicable to wirednetwork models)
- 4.1.Set IP Address
  - 4.1.1.Automatic Setting
  - 4.1.2.Manual Setting
5. Wireless network setup (applicable to Wi-Fi models)
- 5.1.Basic structure mode
- 5.2.Wi-Fi Direct mode
- 5.3.Wireless network setup FAQs
6. Web server
- 6.1.Visit the embedded Web server
- 6.2.Use Web server to manage printer
7. Print
- 7.1.Print Function
- 7.2.Print Settings
- 7.3.Cancel printing
- 7.4.Printing Mode
  - 7.4.1.Printing with the Automatic Feeder Tray
  - 7.4.2.Printing with manual feed tray
- 7.5.Automatic Two-Sided Printing
  - 7.5.1.Duplex printing unit setup
  - 7.5.2.How to carry out auto duplex printing
- 7.6.Fine mode printing
- 7.7.Mute printing
- 7.8.Auto shut-off setting
- 7.9.Open Help Document
8. Copying
- 8.1. Copying function
- 8.2. Copying method
- 8.3. Copying cancel
- 8.4. Common copying setting
- 8.5. ID card copying setting
- 8.6. Receipt setting
  - 8.6.1.Intensity
  - 8.6.2.Paper setting
9. Scan
- 9.1.Pull Scan
- 9.2.Mac System Scan
  - 9.2.1.ICA Scan
  - 9.2.2. TWAIN Scan
- 9.3. Push Scan
- 9.4. Cancel Scan Job
10. Fax
- 10.1. Connect Devices
- 10.2. Fax Settings
- 10.3. Fax Functions
- 10.4.PC-Fax
  - 10.4.1.Sending Fax with PC-Fax
11. Mobile Print/Scan/Fax
- 11.1."Pantum" APP
- 11.2.Mopria mobile print
- 11.3.NFC function
  - 11.3.1.Preliminary preparations
  - 11.3.2.How to use NFC function to print
- 11.4.AirPrint mobile print
12. General Settings
- 12.1.System Settings
- 12.2. Network Settings
- 12.3. Network Information
- 12.4. Print information report
- 12.5. Residual amount of toner
- 12.6. Configure the e-mail address book
- 12.7. Configure the FTP address book
- 12.8. Online upgrade
13. Routine Maintenance
- 13.1.Cleaning the Printer
- 13.2.Toner cartridge and drum component maintenance
  - 13.2.1.About toner cartridge and drum component component
  - 13.2.2.Replace toner cartridge and drum component
14. Troubleshooting
- 14.1.Cleaning Jammed Paper
- 14.2.Software Failure
- 14.3. Error Message
- 14.4. Common Troubleshooting
  - 14.4.1.Common Trouble
  - 14.4.2. Image Defects
- 14.5. Fax faults
15. Menu Structure
16. Product Specifications
- 16.1.Overview of the Specifications
- 16.2.Print Specifications
- 16.3.Copy Specifications
- 16.4.Scan Specifications
- 16.5.Fax specification (applicable to machine with a fax)

1) Use WPS method to perform steps below to start wireless network on printer. (Please refer

to Chapter 5.1.2fordetailedWPSconfiguration)

2) Judge if the printer is successfully connected according to the status of Wi-Fi indicator

onprinter.Ifconfigurationfailed,pleaseclick“Previous”toconfigure again;if

configuration succeeded,

pleaseclick“Done”tocompleteconfiguration.

Note:•If the printer cannot be used normally after wireless network setup is finished,

please install the drive again.

