User Manual

72670-3-11-2014
Mounting Instructions
Save these instructions
Page 4
Insect Inn Ultra contents:
 One Ultra Cover Shell Top.
 One Ultra Cover Shell Bottom.
 One Wall Anchor Kit.
 Two drywall anchors.
 Instructions.
 Screws.
 One Frame Assembly.
 One Cartridge.
 Two UV Quantum Lamps (Bulbs).
Unit location on wall:
Select a wall away from windows or competing
light source. For best results, mounting holes
should be located 66” (1.68 m) above the floor
(Fig. 1).
Mounting unit to wall:
1. As guide to hanging unit locate wall studs if
possible. Mark two locations on the wall for
your fasteners that are 16” (40.6 cm) apart.
Make sure that the marks are level with each
other.
a. Types of Fasteners that can be used:
 Drywall anchors
NOTE: When using the drywall anchors
follow the instructions provided in the
Wall Anchor Kit.
 Two Screws
 Combination of one anchor and one
screw
NOTE: The wall anchor kit provided will accom-
modate these combinations.
2. Use a Phillips head screwdriver to mount the
frame assembly on the wall. The frame as-
sembly must be securely mounted to the wall.
NOTE: For other surfaces, such as concrete,
different fasteners or anchors maybe required.
These types of fasteners are not included.
16”
(40.6 cm)
Drill 1/4”
(6.5mm) hole
Drywall anchor
Anchors are for drywall
where wall studs are
unavailable
1 1/4” screw
Locate mounting holes
approximately 66” (1.68 m)
above the floor
Fig. 1
Fig. 2
72670-3-11-2014
Insect Inn Ultra ™
Page 5
Lamp and Cartridge Installation:
Note: Unit must be securely mounted to
the wall before you proceed with the in-
stallation of Lamps & Cartridge
1. Remove the ultraviolet lamps from the box.
Insert the lamps into the lamp sockets by
aligning the pins of the lamp with the light
socket and twist 90 degrees. (fig. 3)
NOTE: It is recommended to replace the
ultraviolet lamps every eight months of
use to maintain optimum performance of
the unit.
At eight months of contuninuous use the
UV output of the lamps have lost
approximately 30% effectiveness and
should be replaced. After this time the
lamp may still light but is no longer
emitting enough of the special UV light
frequency required for an effective insect
catch.
2. Rotate the drive spool of the cartridge in the
direction of the arrow shown on the drive
spool until the glue surface spans the full
length of the cartridge. (fig. 4)
NOTE: About 11 to 12 rotations will be
required.
3. Position the cartridge on the front of the motor
enclosure. Push the cartridge in until it stops.
(fig. 4 & 5)
Replacement Quantum lamps: part # 72651
2 Quantum Lamps Required
Ultraviolet Lamp/Cartridge Installation
Frame
Assembly
Lamp Socket
Fig. 3
Fig. 4
Fig. 5
Ultraviolet Lamps
Drive Spool
Cartridge
Lamp Socket
Motor Enclosure