Installation Instructions

Spectra 1759MG 43
13.2 Programming Access Codes
Access codes are personal identification numbers that allow you to enter certain programming modes, arm or disarm your system
as well as activate or deactivate PGMs. The Spectra security system supports the following:
System Master Code arms or disarm partitions using any arming method and can create, modify or delete any user access
code. Only the System Master Code can modify or delete user access codes assigned to both partitions.
Master Code 1 is permanently assigned to partition 1 and can be used to create, modify or delete user access codes that are
assigned to partition 1.
Master Code 2 is permanently assigned to partition 2 (except when partitioning is disabled, Master Code 2 will be assigned to
partition 1) and can be used to create, modify or delete user access codes that are assigned to the same partition.
45 User Access Codes (including 1 Duress code)
13.3 Disarming & Deactivating an Alarm
To disarm an already armed system or to deactivate an alarm, simply key in a valid access code. Program a designated entry/exit
point, such as the front door or the garage door with an entry delay timer. When these entry/exit point are opened (breached), it
will set off a timer. The system will not generate an alarm until this timer elapses, giving users enough time to enter the premises
and disarm the system. Any user can disarm the system, except users have been assigned the Arm Only Option.
[
FORCE]
or [16]
Keypad Fault If the keypad is no longer communicating with the control panel, the [TBL] or [TRBL]
will flash, the [FORCE] key will illuminate (the LCD keypad displays “Keypad Fault”)
and the keypad will emit four consecutive beeps at 5-second intervals. Press any
key on the keypad to terminate the “beeping” sequence. When communication has
been restored, the system will revert to previous status.
[
BYP]
or [12]
Module Loss A bus module is no longer communicating with the control panel. The module’s
supervision option must be enabled in section [129].
[
MEM]
or [13]
Wireless Transmitter
Supervision Loss
One or more wireless transmitters are no longer communicating with the receiver.
If you press the [MEM] key, the keypad will display which zones are in trouble.
How Do I Program Access Codes?
1) Press [ENTER].
2) Key in the [
SYSTEM MASTER CODE] or [MASTER CODE].
3) Key in 3-digit [SECTION] (see Table below).
4) Key in new 4- or 6-digit [ACCESS CODE].
[ENTER] flashes. Return to step 3.
How Do I Delete Access Codes?
1) Repeat steps 1 to 3 (see above).
2) Press the [
FORCE] key once for each digit in the access code (4 or 6 times) until the keypad emits a confirmation beep.
Section User Codes
[001] User Code 001 = System Master Code
[002] User Code 002 = Master Code 1
[003] User Code 003 = Master Code 2
[004] to [047] User Code 004 to User Code 047
[048] User Code 048 or Duress Code
How Do I Disarm the System or Deactivate an Alarm?
1) Key in your [ACCESS CODE]*.
The arm or alarm indication will turn off and the keypad will emit a confirmation beep.
*IF YOU HAVE ACCESS TO BOTH PARTITIONS :
Press the key corresponding to the partition you wish to Disarm or to Disarm both partitions, press the [1] key then after the
confirmation beep press the [2] key.
Table 11: Trouble List
LED # Description Details