Programming Guide

Spectra 1759MG - 24 - Programming Guide
Wireless Features
Do not cut, bend or alter 1759MG’s antennae and ensure that electrical wires do not cross over the antennae, as this
may affect signal reception.
Zone Assignment
The serial number can be located on the inside of the transmitter or you can use the Serial Number Display feature (see
page 24).
Also, refer to Zone Recognition Table on page 6 .
Section # Serial #
[601] ___/___/___/___/___/___=
EXPANSION INPUT 1
[602] ___/___/___/___/___/___= EXPANSION INPUT 2
[603] ___/___/___/___/___/___= EXPANSION INPUT 3
[604] ___/___/___/___/___/___= EXPANSION INPUT 4
[605] ___/___/___/___/___/___= EXPANSION INPUT 5
[606] ___/___/___/___/___/___= EXPANSION INPUT 6
[607] ___/___/___/___/___/___= EXPANSION INPUT 7
[608] ___/___/___/___/___/___= EXPANSION INPUT 8
Bold = Default Setting
Serial Number Display
Section # Description
[630] Press the anti-tamper switch of the Magellan Wireless Transmitter. The keypad will emit a confirmation
beep. On LED keypads, press the [
ENTER] key to view the digits one at a time. On LCD keypads, the first
3 digits of the serial number will appear. Press the [
ENTER] key 3 times to view the next 3 digits. Continue
activating the desired transmitters or press [
CLEAR] to exit.
Signal Strength Display
Section # Description
After entering the desired section, activate the Magellan Wireless Transmitter by opening/closing the zone
or by pressing the anti-tamper switch. Always ignore the first reading as it won’t be accurate. An average
reading of 3 or higher is acceptable.
[631] Display Signal Strength of Expansion Input 1 - Section [601]
[632] Display Signal Strength of Expansion Input 2 - Section [602]
[633] Display Signal Strength of Expansion Input 3 - Section [603]
[634] Display Signal Strength of Expansion Input 4 - Section [604]
[635] Display Signal Strength of Expansion Input 5 - Section [605]
[636] Display Signal Strength of Expansion Input 6 - Section [606]
[637] Display Signal Strength of Expansion Input 7 - Section [607]
[638] Display Signal Strength of Expansion Input 8 - Section [608]
Section [610]: General Options
Option OFF ON
[1] Wireless transmitter check-in supervision N Disabled N Enabled
[2] Check-in supervision interval N 24h N 80min
[3] to [7] Future use N N/A N N/A
[8] Tamper Supervision N Disabled N Enabled