User's Manual

Master Quick Menus
User
Delays
Time and Date
Communicate with WinLoad
Step Action Details
1
[] + [
MASTER CODE]
The [ ] key will flash. LED/key on = programmed user.
[PARTITION MASTER CODE] may also be used.
2 [USER NUMBER] MG32LRF/MG32LED/MG32LCD =2 digits: 01 to 32
MG10LEDV/H = 1 digit: 1 to 0(10)
3 [CODE] Enter 4- or 6-digit code.
4 [CONFIRM CODE] Re-enter 4- or 6-digit code.
5 [LEARN REMOTE] / [ENTER] Press a button on the designated remote or [ENTER] to skip. Goes to the next available
user, or if partitioned, go to step 6.
6 [1] and/or [2] + [ENTER] Assign the user to one or both partitions and press [ENTER]. By default, users are
assigned to partition 1. Goes to next available user.
Notes By default: User 1 has access to both partitions, User 2 has access to partition 1 only, and User 3 has access to partition
2 only. These settings cannot be modified.
Step Action Details
1
[] + [
MASTER CODE]
The [ ] key will flash. [PARTITION MASTER CODE] may also be used.
2 [TBL]
3 [1] = Entry Delay 1 (sec.)
[2] = Entry Delay 2 (sec.)
[3] = Exit Delay (sec.)
[4] = Bell Cut-Off (min.)
4 [000] to [255] Enter a value between 000 and 255 (000 = default value).
Step Action Details
1
[] + [
MASTER CODE]
The [ ] key will flash. [PARTITION MASTER CODE] may also be used.
2 [TBL]
3 [5]
4 [HH:MM] Enter time. If HH = 13 or more, skip to step 6.
5 [TIME FORMAT] Enter time format ([1] = 24hr; [2] = AM; [3] = PM).
6 [YYYY/MM/DD] Enter date.
Step Action Details
1
[] + [
MASTER CODE]
The [ ] key will flash. [
PARTITION MASTER CODE] may also be used.
2 [MEM]
3 [1] = Start communication
[9] = Cancel communication