User's Guide

14 User Guide
Bypass Programming
You can bypass certain zones when you arm the system. When a zone is bypassed, it will be ignored the next time you arm the
system. Once the system is disarmed, the system will “unbypass” the zone. Zones that can be bypassed are defined by your
installer. To bypass a zone:
Fire zones cannot be bypassed.
One-Touch Arming
If enabled by your installer, you can arm your system with the following arming methods simply by pressing and holding (for three
seconds) the appropriate function key. You do not have to enter your User code. See Figure 1 on page 7 for the location of the
function keys. Table 1 below shows what function keys can be used for one-touch arming.
Table 1: One-touch Arming Keys
* = To Instant arm your system using one-touch arming, press and hold the [
STAY ARM] key and then during Exit Delay mode, press
and hold the [
STAY ARM] key once more.
Function Key Arming Method
key
Stay arm (page 13)
key
Instant arm* (page 13)
key
Regular arm (page 12)
Press
until
desired
zone
The light will turn ON whenever a
zone or multiple zones are bypassed.
menu next byp